Even though this midsize SUV was given some fairly reliable engines at the factory, many owners do you report having problems with their 42RLE transmission. The most common of these Jeep liberty transmission problems is slipping between gears, or a noticeable delay between shifts.
In respect to this, Is the Jeep 3.7 a good engine?
The 3.7L is a very good engine. It provides plenty of torque so it’s very adequate for off-road use and even when towing. The downside of the 3.7L is street/expressway driving when you want acceleration. The Commander is heavy, and the 3.7L accelerates noticeably more slowly compared to the 4.7L and 5.7L.
Furthermore, How long does a Jeep Liberty transmission last?
But on average, we’ve seen the Jeep Liberty transmission last for between 130,000-180,000 miles. A high quality replacement transmission however, can last considerably longer if all of the factory design flaws have been addressed and the vehicle has been maintained.
Additionally, How much does it cost to replace a Jeep Liberty transmission?
The cost of your Jeep transmission repair or rebuild will depend on which parts need to be replaced and how many service hours the project will require. However, the average transmission replacement cost starts at about $1,800 and can cost as much as $3,400.
How do you reset the transmission on a Jeep Liberty? Cycle the key in the ignition to the “on” and “off” positions three times without starting and then start the Jeep Cherokee and the system may be reset. You can also try disconnecting and reconnecting the battery.
16 Related Questions Answers Found
Are Jeep Commanders expensive to fix?
Cost. The average total annual cost for repairs and maintenance on a Jeep Commander is $639, compared to an average of $784 for fullsize SUVs and $652 for all vehicle models.
How much horsepower does a 3.7 have?
Ford 3.7L Ti-VCT V-6 Specs
| Engine: | Ford 3.7L Ti-VCT V-6 | |
|---|---|---|
| Peak Horsepower: | 302 hp @ 6,500 rpm | |
| Peak Torque: | 278 lb-ft @ 4,000 rpm | |
| Fuel Economy: | 4×2 Pickups | 17 city/23 hwy/19 combined mpg |
| 4×4 Pickups | 16 city/21 hwy/18 combined mpg |
How many miles a gallon does a Jeep Liberty get?
Jeep has manufactured models of Liberty 4WD for 6 years. They average 17.0 combined miles per gallon , with the latest 2012 Liberty 4WD above average at 17 combined MPG.
…
Fuel Efficiency.
| Vehicle Model | 2008 Jeep Liberty 4WD |
|---|---|
| Combined MPG | 18 |
| Highway MPG | 22 |
| City MPG | 16 |
Why did jeep discontinue the Liberty?
Towing capacity was 5,000 pounds (2,268 kg). Jeep discontinued the Liberty CRD for the American market because it could not meet tougher 2007 emissions standards for diesel engines.
How many miles can a Jeep go?
A Wrangler can typically reach 280,000 miles before significant problems begin to surface. But well-maintained models exceed 20 years and over 400,000 miles. The Wrangler is built for the outdoors and designed to tackle tough terrain, contributing to its longevity.
Is it worth it to fix transmission?
Transmissions are one of the most expensive repairs that you can make on a vehicle. … If the car is relatively new and in great condition other than the transmission, then it is probably worth fixing. Other reasons to fix the transmission of a vehicle include you having a vintage car that is worth the money to fix.
Is it cheaper to rebuild a transmission or replace it?
Generally, if a repair estimate costs more than a rebuild, then the rebuild is the service to go with. If the cost of a replacement transmission costs less than a repair or rebuild, then the replacement is the best alternative. Most importantly, you should only use the services of transmission professionals.
Is fixing a transmission worth it?
Transmissions are one of the most expensive repairs that you can make on a vehicle. … If the car is relatively new and in great condition other than the transmission, then it is probably worth fixing. Other reasons to fix the transmission of a vehicle include you having a vintage car that is worth the money to fix.
What are the signs your transmission is going out?
Here are 10 signs of a failing transmission.
- Burning Smell. A burning smell should always raise a red flag. …
- A Low Level of Fluid. …
- Check Engine Light. …
- Abnormal Appearance of the Transmission Fluid. …
- Odd Noises. …
- Sluggish Performance. …
- Grinding and Shaking. …
- Hard to Put the Transmission in Gear.
How do I get my jeep out of limp mode?
If your vehicle goes in limp mode while driving, find a safe place to stop and restart the engine. Allow the car to stay completely off for at least one minute before you restart it. In many cases, an engine restart will reset the limp mode and allow the vehicle to operate normally.
How do I reset my Jeep transmission?
Reset Automatic Transmission Adaptation
- Press the gas pedal down and keep it pressed.
- Turn ignition on without starting the engine.
- Keep ignition on (engine off) and the gas pedal pressed for 30 seconds.
- Turn the ignition off.
- Release the gas pedal.
How do I reset my Jeep PCM?
New Member
- Disconnect the POSITIVE battery Terminal and touch it to ground for 30 seconds to discharge the PCM capacitors, which maintain the Adaptive Memory.
- Reconnect the Battery Cable.
- Turn Ignition Switch to the “On” position but DO NOT start the engine.
- Turn Headlight On.
- Turn Headlights Off.
- Turn Ignition Key Off.
Do Jeep Commanders have a lot of problems?
Jeep Commander Reliability Problems
Commander owners have made 255 complaints over 5 model years. Using our PainRank™ system we’ve ranked it 4th in overall reliability out of 9 Jeep models , with real engine and interior concerns.
Are Jeep Commanders safe?
The Jeep Commander is a comfortable, safe, reliable, and well-performing vehicle. … The Commander’s versatility is due in part to its powerful four-wheel drive. In terms of power, the base model comes with a V6 engine with the option to upgrade to a 4.7L Magnum or 5.7L Hemi V8.
Why did jeep stop making commanders?
For those of you who don’t know, the Jeep Commander was Jeep’s 3-row SUV — a larger, boxier Grand Cherokee, for people who wanted the Jeep brand name, but needed more space. … Unfortunately, the Commander wasn’t tremendously well received, mainly due to quality issues, and Jeep got rid of it after the 2010 model year.
How long do 3.7 engines last?
Some engines will report major issues as early as 75,000 miles while we have also read plenty of posts of the 3.7 Magnum lasting well beyond 200,000 miles and even into 300,000 miles. Overall, when properly maintained, these engine should be good for at least 200,000 miles.
How long will a Ford 3.7 last?
In general, 3.7-liter Cyclone engines have proven to be very reliable. With proper and timely maintenance, the life expectancy is well over 200,000 miles (300,000 km).
Is the 3.7 an EcoBoost?
There are other options out there – meet the 3.7L V6 and 2.3L I-4 EcoBoost engines. With both engines in the 300 horsepower range, these non-V8 Mustang engine options are no slouch when it comes to power.
Don’t forget to share this post !
