Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
In respect to this, How much does it cost to reset the airbag light?
Number 1 — Reset Airbag Light
This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
Furthermore, What happens if you disconnect the airbag light?
You may have made the mistake of turning on the key while installing your car radio without plugging in car airbag components. Doing this will cause your airbag light to flash, and it can be distracting if you leave it on as it is. … Turning off the airbag light yourself can save you a trip to your car dealer.
Additionally, How do I get the SRS light off Mercedes?
Unfortunately, the SRS Airbag light doesn’t reset on its own. Even if the problem has been addressed, you will need an Airbag scanner to reset the light. Very often the light goes on because of a dying battery. But once the light is on, it will stay on even when you install a new battery, until you manually reset it.
Where is the fuse for SRS light? The fuse block is on the driver’s side of the engine compartment. Pull out the SRS fuse. In most models, this is fuse #40, located in the lower right corner of the fuse block.
16 Related Questions Answers Found
How do I get the airbag light off?
How to Turn Off the Airbag Light
- Turn on the ignition switch with your car key. …
- Wait for the airbag warning light to turn off. …
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
Can you sell a car with the airbag light on?
You can sell it, but if someone asks about the airbag light, you should tell them what you know about it.
Who can check my airbag light?
The first thing you should do is have your car checked by a qualified mechanic at your local garage. It is vitally important that you have diagnostics run to find the cause of the airbag light and to have the problem fixed as soon as possible so your airbags will work again.
Is there a fuse for the airbag light?
One fuse in particular, fuse #13 is a likely culprit. If your airbag light is on and your rear windshield wiper doesn’t work, then it’s a pretty good indication that you need to change fuse #13 and possibly others. Blown fuses can definitely cause the airbag light to come on.
What does the airbag light look like?
The SRS warning light on the dashboard usually looks like a side view of a person sitting in a seat with a seat belt on, with a large circle (the airbag) in front of the person. It will normally light up briefly each time you start your vehicle, and then go off.
Can the SRS light be reset?
How do you reset the SRS light? It should be noted that turning off the airbag warning light will not fix any problems. … Only reset the light after the necessary repairs have been completed. A professional can turn off the light (and clear the corresponding trouble codes) with an OEM-level scan tool.
What does SRS light mean in Mercedes?
What is your Mercedes SRS light? “SRS” stands for Supplemental Restraint System. It has to do with your safety restraints, which include your airbags and seatbelts. Keeping these in good repair can keep your safe in an accident.
Is there a fuse for the SRS light?
One fuse in particular, fuse #13 is a likely culprit. If your airbag light is on and your rear windshield wiper doesn’t work, then it’s a pretty good indication that you need to change fuse #13 and possibly others. Blown fuses can definitely cause the airbag light to come on.
Is there a fuse for airbag?
The airbags won’t be activated by the fuse. The whole system on most cars is inoperative if the service air bag light is on.
What is the SRS fuse?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. … The fuse will not activate the airbags. Also on most any car if the service airbag light is on the whole system is inoperative.
What if your airbag light is on?
When this light comes on, it indicates that a problem has been detected in the system, and one or more airbags may not inflate in the event of a collision. While it’s possible that all the airbags could work as intended even with an SRS warning light, a failure in the airbags is a significant safety concern.
Can you reset airbag light with OBD2?
OBD2 scanner can read fault car code and reset SRS. … However, you need to buy an OBD2 scanner that is capable of reading SRS light codes and resetting it. There are many OBD2 scanners on the market. They work with 1996 and newer models and can solve not just SRS issues but other basic and advanced problems as well.
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. … When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.
How do I know if my airbag sensor is bad?
Symptoms of a failing airbag sensor
You can easily tell if the sensor is functioning if the airbag warning light on the dashboard is illuminating every time you start the vehicle. But, if the airbag warning light stays illuminated after starting the vehicle, this is an indication of an airbag sensor problem.
Will airbags deploy if SRS light is on?
The light coming on tells you that there’s a problem with your car’s airbag system. The first and most important thing to remember if your airbag warning light comes on is that, should you be involved in an accident, your airbags will not deploy.
How do I fix my SRS light on my Mitsubishi?
How to reset airbag light on a Mitsubishi
- Plug the Mitsubishi airbag scanner into the OBD2 port under the dashboard, driver’s side.
- Turn on the ignition and allow the scanner to power on.
- Select your Mitsubishi model and year. …
- Select SRS / Airbag Control unit from the main menu.
- Select Read Fault Codes.
Is the SRS light an MOT failure?
Answer. If your airbag light is on or your SRS supplementary restraint system warning lamp is on it will fail its MOT. … You can also try to reset the airbag or SRS light which may resolve the problem.
What is SRS malfunction?
SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system.
What does SRS mean on text?
Serious. On social media and in texts, SRS is most commonly used as a contraction of the word “Serious.” In this context, it is often found in terms such as ‘SRS BZNS’ (Serious business) and ‘Y SO SRS?’ (Why so serious?).
Don’t forget to share this post !
